How to load media in Tally Dascom DL820 Label Printer
1. Step One
① Open the top cover.
② Push the blue Release Lever to release the
head module.
③ Lift the Sensor Arm.
④ With the printing surface facing up, clam the
media roll between the Media Holder and the
Media Width Adjuster.
⑤ Load the clammed roll into the media
compartment.
2. Step Two
① Route the media underneath the Damper.
② Move the Right Media Guide to fit the media
width.
③ Return the Sensor Arm to its original position.
3. Step Three
①If new media, read Section 2.4.2 or 2.4.3 to
relocate the media sensors.
② Push the blue Engage Handle to lock up the
print head module.
4. Step four
Making a media calibration ensures the printing starts with the correct position on the fresh media. Hold the ►►button and then turn on the power. After the beeper sounds twice, release the button to complete the media calibration process.